Radar Altimeter Smartmicro

We will configure this device in Pipe direcly. If we click in:

Examples - Step 1

Step 1

Pipe will display you the Setup Toolbar (for more information see Setup Toolbar):

Examples - Step 2

Step 2

Following the steps you can access successfully in the CAN connections data sheet, here we will configure our altimeter. As you can see, you can work with two independent CAN data buses (A and B), each one have two cables (High and Low) one with positive polarity and another one negative, the figure of the upper left corner shows you what pins they are.

In this example we have configured the Smartmicro Radar-Altimeter in channel B, the recommended values to this configurtion are:

Examples - Step 3

Step 3

Examples - Step 4

Step 4

In Telemetry section you can add or delete messages clicking in “+” or “-”

Examples - Step 5

Step 5

If you have followed the indications and introuced the values shown in previous figures, your radar-altimeter will be configured.

To get more information of the Smartmicro Radar - Altimeter datasheet you can go to: