Veronte Configuration

Overview

In this section, it is explained how to configure Veronte Units using Veronte Pipe. Each feature available is described in detail in following sub-sections.

Firstly, the user will find how to manage configuration files: import, export, update, etc. Later, this manual will focus on the setup toolbar, this allows the user to change the main settings of the Veronte Units according to the aircraft (Control Loops, Installation, etc.) and mission (Phases, Guidance, etc.) to perform.

Finally, the manual explains how to check Veronte’s license, where the user can see the license ID and its status.

Side Panel Options

The Side Panel allows the user to manage Veronte Units and Configuration files. In this panel each item is displayed, when an autopilot is connected it will appear automatically. The following image shows both items and the options available.

Side Panel Options

The next table gives a brief overview of each option.

Item	Description
Discard	Discard all changes
Save	Save all modified data
Setup	Displays the setup toolbar
Operation	Displays the operation toolbar
Set Operation	Choose one operation to be loaded
Export	Export configuration on Veronte to disk in .ver or PDI files
Import	Import a configuration from disk
About	Displays information on Veronte SN, License and Status (only available for connected Veronte configurations)
Remove	Remove the selected configuration (only available for offline configurations)
HIL	Hardware in the loop simulation
Advanced	Update Veronte Unit and Reboot it