Connections

If you click in:

Connections Tool

You can open the connections menu:

Connections Menu

Where you can configure:

• New veronte Units: When using Veronte Pipe for the first time, it is necessary to configure the connection with Veronte Units. Once it has been done, Veronte Units will be automatically detected by Veronte Pipe.

New Veronte

In case of using a different interface of connection, it may require changing some parameters.

New Veronte Configuration

The following parameters can be edited in the menu shown above:

• Baudrate: this field specifies how fast data is sent.

• Parity: this field is a way of low-level error checking. It can be in odd or even.

• Data Bits: this field defines the bits number of the message.

• Stop: number of the stop bit.

Type	Bits
Start	1
Data	4-8
Parity	1-2
Stop	1-2

• TCP Server: Pipe gets information from the configured Port of the TCP (Transmission Control Protocol) Server.

TCP Server

• Send-telemetry: Pipe sends the telemetry document through the configured parameters.

Send Telemetry