Veronte products¶
This section explains how to integrate MEX with Veronte products.
Autopilot 1x connection¶
![../../_images/pinout_MEX.png](../../_images/pinout_MEX.png)
Connector for MEX¶
![../../_images/pinout_1x.png](../../_images/pinout_1x.png)
Connector for Autopilot 1x - HEW.LM.368.XLNP (frontal view)¶
For proper operation, the connection between MEX and Autopilot 1x pins should be like this:
Autopilot 1x |
MEX |
|||
---|---|---|---|---|
PIN Nº |
Signal |
Color |
PIN Nº |
Signal |
25 |
CANA_P |
White-Black |
22 |
CAN(A) P |
26 |
CANA_N |
Brown-Black |
23 |
CAN(A) N |
28 |
CANB_P |
Yellow-Green |
20 |
CAN(B) P |
29 |
CANB_N |
Pink-Green |
21 |
CAN(B) N |
30 |
GND |
Yellow-Pink |
24 |
CAN GND |
Note
If only CAN A or CAN B has been configured in the software for communications, only the corresponding pins must be connected.
Important
Integration is also possible by connecting CAN A of the Autopilot 1x to CAN B of the MEX and vice versa, i.e. it does not necessarily have to be CAN A-CAN A or CAN B-CAN B.
However, any connections made must be consistent with the configuration made at software level in 1x PDI Builder and MEX PDI Builder.