Software Installation

MC01 is configured with a computer via CAN. Since there is normally no direct connection to a PC via CAN, an Autopilot 1x is used as a tunnel to connect via CAN to the MC01 and via USB, RS-232 or RS-485 to the PC.

To configure a Veronte device (CEX, MEX, 1x or 4x) and control the MC01, use its respective PDI Builder. An example can be found in the MC01 - Integration examples section of the 1x PDI Builder user manual.

The physical connections can be summarized with the following diagrams (including power supply):


USB connection


Serial connection

To install the required software and configure Veronte MC01, read the MC01 Software Manual.