Software Installation¶

Veronte Gimbal 10z is moved and visualized using a Veronte Autopilot 1x. Hence, the configuration is done in the Autopilot 1x

To configure the Autopilot 1x, it is required a connection with a computer. There are two ways to make the connection between a computer and Veronte Autopilot 1x: via USB or RS (232 or 485) with a converter RS-USB.

../_images/usb.png — **USB connection**¶

../_images/serial.png — **Serial connection**¶

To know which pins are employed for each connection, read the pinout of Autopilot 1x and the pinout of Gimbal 10z.

To install the required software and configure Autopilot 1x for Gimbal 10z, read the Gimbal Software Manual.