Jetibox Telemetry

CEX can simulate a Jetibox to read telemetry from legacy Jeti devices.

Note that the serial port will be totally reserved for this, so it will not be usable to other things and the IO Manager affecting it wil be ignored.

We shall configure the serial port with: 9800, 2 stop bits, Odd parity and address mode ON

and link the specific Jetibox IO consumer to that port:

Also the sequence to retrieve the data shall be configured in the Jetibox consumer:

For example, to read the Actual Voltage from a Jeti MasterSpin 220 we should configure the Consumer with (use big endian in all messages):

1. Expected text: “CONTROLLER TYPE MasterSpin 220~”

   Action: Down

   • Matcher(32) “CONT” 0x434F4E54 (1129270868)

   • Skip(24*8) 192

   • Matcher(32) “220~” 0x3232307E (842150014)

2. Expected text: “MeasureOrSetting MEASURE ~”

   Action: Down

   • Matcher(32) “Meas” 0x4D656173 (1298489715)

3. Expected text: “Max Temperature”…

   Action: Down

   • Matcher(32) “Max ” 0x4D617820 (1298233376)

4. Expected text: “Min Temperature”…

   Action: Down

   • Matcher(32) “Min ” 0x4D696E20 (1298755104)

5. Expected text: “Actual Temperatu”…

   Action: Down

   • Matcher(32) “Actu” 0x41637475 (1097036917)

6. Expected text: “MaxCurrent”…

   Action: Down

   • Matcher(32) “MaxC” 0x4D617843 (1298233411)

7. Expected text: “MinCurrent”…

   Action: Down

   • Matcher(32) “MinC” 0x4D696E43 (1298755139)

8. Expected text: “Max Voltage”…

   Action: Down

   • Matcher(32) “Max ” 0x4D617820 (1298233376)

9. Expected text: “Min Voltage”…

   Action: Down

   • Matcher(32) “Min ” 0x4D696E20 (1298755104)

10. Expected text: “Actual Voltage 11,86 V “

    Action: Nop

    • Matcher(32) “Actu” 0x41637475 (1097036917)

    • Skip(12*8) 96

    • Ascii int(2), separartor(‘,’), decimal(2)