Joysticks

To use the joystick in the system, connect the PPMout of the trainer port to a digital input of Veronte Autopilot 1x and configure that digital input in the corresponding software.

If the PPM level is 3.3V, pins 1-8, 10-17 and 55-58 pins can be used.

Veronte is compatible with standard Pulse Positon Modulation (PPM) signals, Futaba radios between 8 and 12 channels are recommended.

Electrical - Futaba T10 Joystick

Futaba T10 Joystick

Electrical - Futaba T10 pinout

Futaba T10 pinout

Electrical - PPM signal

PPM signal

As default, channel 8 is reserved for manual / auto switch. High level is used for automatic flight and low level for manual control. This channel can be configured on Veronte software.

Warning

Caution!! PPM signal must be into the Veronte voltage ranges. Some joysticks may need an adaptation board, please ask our team to check compatibility.

Veronte connector for CS is provided with 3.5mm stereo plug connector as follows:

Electrical - Jack pinout

PPM pinout

Electrical - Jack

PPM connector