Software Installation

Firmware Update

To update the CEX firmware from version 6.4 to 6.8, an additional app is required, Veronte Updater.


The file with the new CEX software version will be uploaded to the FTP folder when requested by the customer.

Connection and Configuration

There are two ways to make the connection to configure CEX: via Veronte Autopilot 1x or direct connection.

  • Via Autopilot 1x

    It is usual to have a CEX in a system that does not allow to directly connect CEX to a PC. In that situation, it is possible to configure an Autopilot 1x that is connected via CAN with CEX. To be able to establish a connection between 1x PDI Builder and CEX, please see the Integration Examples section of the CEX PDI Builder manual.


CEX connection through Veronte Autopilot 1x

  • Direct Connection

    By default CEX can establish VCP communications over its SCI-A and SCI-B ports. Using any of these connection, it will be possible to connect it to a PC.


    Direct CEX connection

The CEX software configuration is explained in the CEX Software Manual.