Veronte Configuration


In this section, it is explained how to configure Veronte Units using Veronte Pipe. Each feature available is described in detail in following sub-sections.

Firstly, the user will find how to manage configuration files: import, export, update, etc. Later, this manual will focus on the setup toolbar, this allows the user to change the main settings of the Veronte Units according to the aircraft (Control Loops, Installation, etc.) and mission (Phases, Guidance, etc.) to perform.

Finally, the manual explains how to check Veronte’s license, where the user can see the license ID and its status.

Side Panel Options

The Side Panel allows the user to manage Veronte Units and Configuration files. In this panel each item is displayed, when an autopilot is connected it will appear automatically. The following image shows both items and the options available.

Veronte Configuration - Side Panel Options

Side Panel Options

The next table gives a brief overview of each option.

Item Description
Discard Discard all changes
Save Save all modified data
Setup Displays the setup toolbar
Operation Displays the operation toolbar
Set Operation Choose one operation to be loaded
Export Export configuration on Veronte to disk in .ver or PDI files
Import Import a configuration from disk
About Displays information on Veronte SN, License and Status (only available for connected Veronte configurations)
Remove Remove the selected configuration (only available for offline configurations)
HIL Hardware in the loop simulation
Advanced Update Veronte Unit and Reboot it