License & Safe Mode

License

To access the License you have to open setup, then select Veronte and click on logo24. In this tab you can check you License of your Veronte. You will have a different License Id for each Veronte (so, License Id Veronte Air is different from License Id Veronte GND). To renovate Veronte License, you must connect Veronte to Internet biweekly.

Veronte Configuration - License

License

The license panel is useful to check the following information:

Veronte Configuration - License panel

License panel

The panel is useful to check the following information:

  1. UAV name

  2. UAV Address

  3. Software Version

  4. Autopilot Part Number

  5. Software version

  6. License ID

  7. License State (red)

    • GC: Guidance and Control

    • NAV: Navigation

    • TC: Transmission (RC)

  8. License Expiration Date and Time (blue)

The license state shows the possible action for the selected autopilot (ON=Active, OFF=Not Active). The Ground Autopilot license state for a normal configuration is ON: OFF: ON. The Air state is ON: ON: ON.

Safe Mode

The safe mode is used to avoid malfunctioning when the autopilot is trying to charge a corrupt file.

When Veronte is trying to charge a configuration file in its SD card and there is some problem, the safe mode avoids that the autopilot tries to charge the corrupt file again and again entering then in a loop that would not allow communicating with it. Instead of that, the system charges a default configuration stored in its flash memory and enters in what is called the safe mode, allowing the operator to change the configuration and send it again to Veronte.

It is also possible to force the enter in the safe mode by turning the autopilot off and on quickly. Safe mode displays the following window.

Veronte Configuration -  Safe Mode

Safe Mode

It is possible to Change setup and select the configuration file which will be loaded on the autopilot. When a file is selected, a new window will be displayed in Veronte Pipe showing the version and identification of the configuration file and the autopilot where the file is going to be loaded.

Veronte Configuration -   Upload Configuration – Safe Mode

Upload Configuration – Safe Mode

With this tool, the configuration file is loaded directly on the autopilot. Now Pipe is only a tool to load the file from the computer to the autopilot and the configuration parameters will not be shown in the software window before being loaded on the autopilot.

The other option available allow the user update the Veronte Unit, this is explained in Update Onboard Software.