Antenna Kit C - Yagi 400 MHz

  1. Mount the omnidirectional antenna reading the Omnidirectional Antenna section.

  2. Screw the splitter to the antenna mount with two screws M3 x 30 mm.

../../_images/combiner.png

Note

The splitter receives an electrical signal and sends it to two different antennas.

  1. Attach both adapters for the Yagi antenna with eight screws M3 x 16 mm and their corresponding washers.

../../_images/adapter_yagi.png

Note

The space between adapters can be adjusted according to the width of the antenna.

../../_images/move.png

  1. Insert the Yagi antenna into the adapter according to the polarity. The polarity direction is indicated by an arrow on the antenna.

../../_images/insert_yagi_400.png

  1. Screw the Yagi antenna to the adapters with two screws M6 x 45 mm and their corresponding knobs.

../../_images/screw_yagi_400.png

  1. Connect each plug of the splitter.

../../_images/connect.png

1

Port RF2 of PCS

2

Omnidirectional antenna

3

Yagi antenna