Operation

The T28 is operated with Veronte Ops with its own Veronte Panel. This panel can be displayed accessing the widgets menu in the workspace toolbar. To do this, click on the ‘+’ button \(\rightarrow\) Main \(\rightarrow\) Veronte Panel.

For more information on the Veronte panel widget, please refer to the Main widgets section of the Veronte Ops user manual.

Note

Veronte panels are configured in the autopilot. In consequence, to obtain them it is necessary to connect the computer to the device.

How to open Veronte panels

Veronte Tracker buttons

Note

The buttons of Veronte Tracker panel exist and perform their respective functions because they were programmed with 1x PDI Builder automations.

Veronte panel for T28

\(\Rightarrow\) Trim buttons. They adjust the T28 position.

\(\Rightarrow\) GPS indicator. It indicates whether the GPS has a valid position or not.

\(\Rightarrow\) Target indicator. It indicates whether the T28 is receiving the target position or not.

\(\Rightarrow\) Battery indicator. It shows how much battery power remains:

• Green: > 70 %

• Yellow: 70 % - 40 %

• Orange: 40 % - 15 %

• Red: < 15%

\(\Rightarrow\) Charging indicator. It shows the charging status:

• Green: charging.

• Blue: charged.

• Flashing yellow: discharging.

\(\Rightarrow\) Phase indicator.

\(\Rightarrow\) Phase buttons.

How to operate the Veronte Tracker panel

1. The T28 starts with Initial phase.

2. Once the GPS indicator turns green, it automatically switches to the ready phase.

3. To switch to Ready phase, simply drag the Ready phase button.

4. Once in Ready phase (or during the Initial phase) the T28 orientation must be calibrated. To do this, use the trim buttons to point the antenna north. The internal buttons move the antenna by 1 degree and the external buttons by 10 degrees.

5. Once the T28 is calibrated and the GPS and target indicators are green, drag the Tracking phase button to switch to tracking.

6. To stop tracking, drag the Ready phase button to return to ready.