Connecting SIL & Veronte Pipe

Connecting SIL & Veronte Pipe

  1. Add a UDP serial communication block and connect it to USB data and length.

  2. Add a second UDP serial communication block and connect it to the USB output of veronte.

Simulation - S-Function containing the autopilot embedded code

UDP Blocks

  1. Configure your destination port.

Simulation - S-Function containing the autopilot embedded code

Destination UDP Port

  1. Set an ethernet network in Preferences as shown using the destination port selected before. Check that Local IP Address and Local Subnet Mask have non-zero values.

Simulation - S-Function containing the autopilot embedded code

Destination UDP Port (Pipe)

Pipe v6.6 and higher

In case of using VeronteLink (comunication with Pipe v6.6 or higher) you have to configure the connections tab selecting UPD as connection type and set the configuration as in fourth step.

Simulation - S-Function containing the autopilot embedded code

Destination UDP Port (Veronte Link)