Quick Start

Veronte Gimbal 30z is moved and visualized using a Veronte Autopilot 1x. The Autopilot 1x that controls the aircraft can be configured to control and visualize Gimbal 30z cameras.

../_images/system-overview.png

System Overview

First of all, configure the Autopilot 1x according to the Software installation section , then the Hardware installation section provides instructions on how to physically install the Gimbal 30z.

Requirements

  • A Veronte Autopilot 1x to command and visualize 30z.

  • Power supply of 24 V DC.

  • Veronte Gimbal 30z has not an internal resistor for CAN bus, in case that the Gimbal is at the end of the bus, please place a 120 \(\Omega\) resistor externally

  • A device with ethernet port to receive video signals.

  • A frame with four screwed holes for M4 screws, read Mechanical Assembly for more information.