Software Installation

To configure the software, first of all a Veronte Autopilot must be connected to a PC with Veronte Link. Then the Veronte Autopilot has to be configured with 1x PDI Builder according to MC01. Finally the MC01 can be adjusted with the corresponding PDI builder according to the variant (MC01S or MC01B). These three tasks are referenced in this section.

How to stablish communication between PC and Veronte Autopilot

Follow the instructions from Veronte Link user manual to connect a Veronte device to a PC.

How to configure Veronte Autopilot

After connecting a PC to Veronte Autopilot, communications between Veronte Autopilot and MC01 have to be configured according to the 1x PDI Builder user manual.

How to configure MC01S

In case of using the stepper variant (MC01S) follow the instructions from the VMC Stepper PDI Builder user manual to configure a MC01S.

How to configure MC01B

In case of using the brushless variant (MC01B) follow the instructions from the VMC PDI Builder user manual to configure a MC01B.