Hardware Installation

Hardware Installation

  1. Attach a pole mount to the bottom of the PCS with two screws M3 x 12 mm.

../_images/assembly-step-1.png

  1. Attach a pole mount to the top of the PCS with four screws M3 x 12 mm.

../_images/assembly-step-2.png

  1. Pass the pole through both mounts.

../_images/assembly-step-3.png

  1. Screw two knobs to fix both mounts to the pole.

../_images/assembly-step-4.png

  1. Place the adapter on the top of the pole.

../_images/assembly-step-5.png

  1. Screw one knob and one bolt M5 x 16 mm to fix the adapter on the pole.

../_images/assembly-step-6.png

  1. Screw the support on the adapter with four bolts M3 x 12 mm.

../_images/assembly-step-7.png

  1. Attach the legs to the Gimbal with two bolts M3 x 10 mm for each one.

../_images/assembly-step-8.png

  1. Fix the Gimbal to the support with four bolts M4 x 8 mm.

../_images/assembly-step-9.png

  1. Connect the cables following the Interfaces - Technical section of the present manual.

Note

To know specific details about the electrical assembly, please consult: