Configuration

The following steps show the basic configuration to operate with T28; the rest of the configuration depends on the application and mission.

Air unit

1. Go to → Telemetry → Data to VOpps. Then set the Address to "0xFFFFFFFF (Broadcast)".

2. Add the variables UAV position and Position not fixed from the Disabled window. It is recommended to use the Search bar.

3. Complete the rest of the configuration according to the vehicle and mission requirements, then click on to write the configuration in Autopilot 1x.

Ground unit (T28)

When the ground system is delivered to the customer, it has the necessary configuration to operate. The user only has to verify that the Address of the air unit is correctly configured in the Sniffer.