Veronte products¶

Connection with Autopilot 1x via CAN¶

No configuration is necessary in CEX, the configuration for communication with Autoilot 1x is set by default.

The configuration required in 1x PDI Builder to communicate with CEX via CAN is explained in the CEX/MEX - Integration examples section of the 1x PDI Builder user manual.

Connection with Autopilot 4x via CAN¶

CAN Reception IDs¶

First, users can setup the receiving CAN Ids for each one of the 3 possible Veronte Autopilots 1x sending data to CEX in the Arbitration menu.

Go to Arbitration menu \(\rightarrow\) CAN Setup panel:

../../_images/can_reception_arbitration_ids.png — **Arbitration - CAN Reception IDs**¶

Note

If arbitration is not enabled, and therefore only one Autopilot 1x is being used, no CAN Ids need to be configured here.

CAN I/O Interconnections¶

Once the CAN IDs are set, users shall configure:

CAN Input Filters to be used (as communication with CEX has to be always through a Filter).
The connection between input filters and data Consumers.

Go to Input/Output menu \(\rightarrow\) CAN I/O panel \(\rightarrow\) Configuration tab:

../../_images/can_io_interconnections.png — **Arbitration - CAN Input Filters**¶

For more information on CAN I/O configuration, see the CAN I/O - Input/Output section of this manual.

Next step is to connect each of the desired data Producers to a CAN Output Filter, and configure both the Producer and the CAN Output Filter:

../../_images/can_io_output_filter.png — **Arbitration - CAN Output Filters**¶