Manual Control Layouts¶
Veronte allows for a wide variety of pilot interface solutions in order to interact with manual flight modes, assisted flight modes (arcade) or payloads.
The following control solutions can be used independently, or in combination to create redundant systems, parallel channels (flight control + payload) or backup solutions.
PPM to Ground Unit¶
Standard setup. Allows the usage of a single radio channel both for stick, control commands and telemetry, minimizing any potential interferences.
PPM to Air Unit¶
Allows for a backup manual channel in case there is a main channel loss and an emergency manual landing is needed. Recommended for initial developement stages where automatic landing phases are not defined yet.
USB to PPM¶
The USB to PPM solution allows for the integration of commercial flight station devices and remote controllers.
Veronte PPM to USB device is sold separately. Please contact email@example.com for more information.
USB to PPM
USB to Pipe¶
Allows the use of any device that is detected as a remote controller by the operative system
This setup is dependent on external hardware and software (PC) and any potential issue will also affect the availability of the stick. It is recommended to use this solution for non-critical systems only. For critical systems (i.e. flight control), use the USB to PPM option instead.
USB to Pipe
The Virtual stick feature allows to integrate as a stick controller any device that can interface with Veronte Ground or Air unit (RS232, RS485, ADC, CAN,…) and can provide control reference values.
While the configuration will be slightly more complex, this feauture allows using a wide variety of devices as flight control interfaces.