Simplified Cooling Circuit Design

This subsection explains how to size a specific layout of cooling design, so the user does not have to calculate any parameters. This layout is intended for one single MC110. In case of desiring to use a different layout or to refrigerate multiple controllers with a single circuit, read the Advanced Cooling Circuit Design.

../../_images/ref.png

Basic diagram of cooling circuit

Each cooling element must accomplish the following requirements:

  • Pump

    • Flow rate: 6 l/min.

    • Minimum pressure: 0.5 bar.

    • Activity: always on (while MC110 is on).

  • Pipes connected to cold plate

    • Water-glicol resistant

    • Able to join with the following ports:

    ../../_images/tube.png

    Port diamaters (mm)

    Tip

    For cold plate connections, it is recommended to use fluoropolymer tubing with 8 mm of outside diameter and 6 mm of internal diameter.

  • Coolant

    • Mixture water-glycol at 50 %, in order to have a freezing temperature below operating conditions.

  • Radiator

    Radiator thermal conductivity (which is related to size) depends on motor power, switching frequency and battery voltage. Depending on each situation, the following tables show the minimum heat transfer of the required radiator.

    Heat transfer for 10 kHz switching frequency (W/ºC)

    Motor power (kW)

    Battery voltage

    800 V

    550 V

    100 V

    15

    50

    50

    150

    30

    100

    100

    *

    45

    100

    150

    *

    60

    150

    150

    *

    75

    150

    200

    *

    95

    200

    200

    *

    110

    200

    200

    *

    Heat transfer for 16 kHz switching frequency (W/ºC)

    Motor power (kW)

    Battery voltage

    800 V

    550 V

    100 V

    15

    50

    50

    150

    30

    100

    100

    *

    45

    150

    150

    *

    60

    150

    150

    *

    75

    200

    200

    *

    95

    200

    200

    *

    110

    250

    250

    *

    Heat transfer for 22 kHz switching frequency (W/ºC)

    Motor power (kW)

    Battery voltage

    800 V

    550 V

    100 V

    15

    100

    100

    150

    30

    100

    150

    *

    45

    150

    150

    *

    60

    200

    200

    *

    75

    200

    200

    *

    95

    250

    *

    *

    110

    *

    *

    *

    Warning

    *: These situations involve an intensity higher to 250 A or overheating.

    Tip

    • The generated heat by the MC110 increases with switching frequency and motor power. But it decreases with battery voltage.

    • Be careful with the change of tube sections. If the coolant transitions from a small to a large section, air bubbles may remain.