Quick Start

This user manual covers the assembly of Shifter. To use it, weld input and output wires according to the Pinout section.

The following diagram and table summarize the Shifter behaviour:

../_images/esquema.png

Input and output diagram

Case

Result

Input binary signal > 1.6 V

Output binary signal = Power supply voltage

Input binary signal < 1.6 V

Output binary signal = 0 V (connected to ground)

Warnings

  • Maximum voltage for input and power supply is 12 V.

  • Minimum voltage for the input signal is 1.6 V to be detected as high state.

  • Make sure Shifter is not thermally very insulated, to prevent overheating.

  • Be careful welding pads and avoid short-circuits between them.