Hardware Installation

Mechanical

R12F OEM Assembly

M4 screws are recommended for mounting. In saline environments such as coastal and oceanic, the screw material must be stainless steel.

../_images/assembly_oem.png

R12F OEM assembly

To weld the cables read the Pinout section of this manual

R12F Assembly

  1. First of all, unscrew the box and the PCB.

    ../_images/unscrew.png

    Unscrew R12F

  2. Then, weld the cables to the PCB following the Pinout section of this manual.

  3. Next, pass the cables through the cable gland and screw the PCB back.

    ../_images/pass_cables.png

    Cables assembly

  4. For mounting, M3 screws are recommended. In saline environments such as coastal and oceanic, the screw material must be stainless steel.

    ../_images/assembly.png

    R12F assembly

  5. Finally, screw the box back.

Pinout

The following diagram shows the holes to weld each cable.

../_images/pinout.png

  • HV IN: Positive of the input power supply (from 14 to 160 V DC).

  • HV GND: Ground of the input power supply.

  • OUT: Positive of the output voltage (12 V DC).

  • GND: Ground of the output supply.

Note

Grounds are not common.