Software applications¶
For configuring MC01, Veronte Link is required to connect an Autopilot 1x to the computer. This autopilot must be configured to operate as a CAN-USB (or CAN-RS) converter in 1x PDI Builder for then, configuring MC01 through its corresponding PDI Builder.
Veronte Link¶
Veronte Link establishes communication between a computer and any Veronte product by creating a VCP bridge. It allows to use multiple control stations and autopilots to be interconnected, operating simultaneously. Veronte Link also includes a post-flight viewer, to reproduce all recorded data from previous flights and generate plots and reports.
For more information, visit the Veronte Link user manual.
1x PDI Builder¶
1x PDI Builder is the main configuration tool to adapt a Veronte Autopilot 1x to a specific application, including user-defined commnication protocols. 1x PDI Builder includes:
Telemetry: real-time onboard UAV metrics, such as sensors, actuators and control states.
Configuration: edit vehicle settings, such as servo trim, interface/port management and modes.
Automations: actions that are automatically executed when a set of configured conditions are accomplished.
Block Programs: Veronte Autopilot 1x can be programmed with a friendly-user programming language.
For more information, visit the 1x PDI Builder user manual.
MC01S PDI Builder¶
MC01S PDI Builder configures the stepper variant of MC01 (MC01S). This application allows to adapt control, communications and telemetry to each motor implementation.
To know more, read the MC01S PDI Builder user manual.
MC01B PDI Builder¶
MC01B PDI Builder configures the brushless variant of MC01 (MC01B). This application allows to adapt control, communications and telemetry to each motor implementation.
To use it, consult the MC01B PDI Builder user manual.