Veronte products

This section explains how to integrate High Speed Pitot Sensor with Veronte products.

Autopilot 1x

Follow the steps below to install the High Speed Pitot Sensor with an Autopilot 1x and configure it, so 1x measures the air speed from the electrical signals of High Speed Pitot Sensor.

Required Material

  • Veronte Autopilot 1x with hardware version 4.8.

  • High Speed Pitot Sensor.

  • Veronte Harness CS for 1x v4.8 with Embention reference P007043.

  • Power supply for 1x (6.5 - 36 V DC).

  • Power supply for High Speed Pitot Sensor (5 V DC).

  • Pneumatic tubing, with 3 mm of outer diameter and 1 mm of inner. Silicone material is recommended.

  • Two T-connectors for the tubing.

Hardware Installation

../../_images/high_speed.png

Electrical and pneumatical connections

The analog pin defines which analog variable is used for configuration.

../../_images/pinout_1x.png

Connector for Autopilot 1x - HEW.LM.368.XLNP (frontal view)

Autopilot 1x Connections

Pin number

Signal

Harness wire color

38

ANALOG_0

Red

39

ANALOG_1

Black

40

ANALOG_2

Pink

22

ANALOG_3

Brown - Blue

23

ANALOG_4

White - Red

Software Installation

Once the High Speed Pitot Sensor is connected, air speed measurements can be monitored with 1x PDI Builder using the variables ADC0 to ADC4. The integration of this device with Autopilot 1x as far as the software is concerned is explained in the High Speed Pitot Sensor - Integration examples section of 1x PDI Builder user manual.