In this panel, Input/Output ports of the Veronte Unit are configured. Veronte Autopilots has 68 pins, each one corresponding to a page of those shown in the lateral menu of the following figure. When selecting a port its pin is displayed on the panel.

Veronte Configurtion - Setup – Connections – GND Pins Displayed

Setup – Connections – GND Pins Displayed

For particular pin colour scheme, the user can click the button on the top right corner above the 68 pin connector picture and access this menu, where each pin is displayed with its own colour.

Veronte Configurtion - Connection 68 Pin Colour Scheme

Connection 68 Pin Colour Scheme

Depending on the port selected, the parameters to be configured are different. The following table shows the type of connections available for configuration in Veronte Autopilot.

Field Description
ADC Analog signal input or external battery voltage measurement.
CAN Configurable Controller Area Network bus A & B.
GPIO/EQEP Enhanced Quadrature Encoder Pulse Input.
GPIO Veronte input/output signals.
I2C I2C (Inter-Integrated Circuit) bus.
PWM Pulse Width Modulation configuration.
Serial Configurable Serial ports RS232 & RS485.

Each connection is associated with a specific pin number, see section Hardware Installation – Electrical for more details.