Connections¶

If you click in:

Connections Tool

You can open the connections menu:

Connections Menu

By default, Autodiscover COMs option is selected to be able to recognize Veronte Units. However, they can be added manually by unchecking this option following the steps below.

New Veronte

In case of using a different interface of connection, it may require changing some parameters.

New Veronte Configuration

The following parameters can be edited in the menu shown above:

Baudrate: this field specifies how fast data is sent.

Parity: this field is a way of low-level error checking. It can be in odd or even.

Flow Control RTS/CTS and XON/XOFF control can be configured if needed.

Data Bits: this field defines the bits number of the message.

Stop: number of the stop bit.

Type	Bits
Start	1
Data	4-8
Parity	1-2
Stop	1-2

TCP Server: Pipe gets information from the configured Port of the TCP (Transmission Control Protocol) Server.

TCP Server

Send-telemetry: Pipe sends the telemetry document through the configured parameters.

Send Telemetry